Home life · Updated
How to Descale a Tassimo Coffee Maker
Quick answer Descaling your Tassimo removes limescale buildup that clogs the machine and affects drink quality. Use the official Tassimo descaling solution (or a compatible citric acid product) and follow the machine's rinse cycle.
What You’ll Need
- Tassimo descaling solution (official or compatible citric acid-based)
- Fresh water
- A large container or sink to collect water (at least 1 liter capacity)
- A clean cloth for wiping spills
Step-by-Step
- Prepare the machine: Turn off the Tassimo and unplug it. Remove any T DISC pod from the holder and discard it. Empty the water tank completely.
- Add the descaling solution: Pour the entire contents of the descaling solution bottle into the empty water tank. If your solution requires dilution, follow the instructions on the package (usually one part solution to one part water).
- Fill with water: Add fresh water to the tank up to the MAX line, mixing the solution.
- Place a container: Put a large container (at least 1 liter capacity) under the drink spout to catch the solution as it runs through.
- Run the descaling cycle: Plug the machine back in and turn it on. Press and hold the descaling button (often the same as the ‘clean’ or ‘start’ button) for about 5 seconds until the descaling indicator lights up. The machine will start pumping the solution through. Let it run until the tank is empty. This may take a few minutes.
- Rinse the tank: Once the tank is empty, remove it and rinse it thoroughly with fresh water. Fill it with clean water only, up to the MAX line.
- Run rinse cycles: Place the container back under the spout. Run at least two full rinse cycles by pressing the start button (or the descaling button again) to flush out any remaining solution. Empty the container between cycles.
- Clean the exterior and finish: Wipe down the machine with a damp cloth to remove any drips. Your Tassimo is now descaled and ready for normal use.
Common Mistakes
- Skipping the rinse: Not running enough rinse cycles leaves a bitter taste in your drinks. Always run at least two full cycles with fresh water.
- Using vinegar or other acids: Vinegar can damage the internal components of your Tassimo. Stick to the recommended descaling solution.
- Forgetting to remove the T DISC: Leaving a pod in the holder during descaling can clog the needle and ruin the pod.
- Starting with a full tank of solution: If you add the solution after filling the tank, it may overflow or not mix properly. Always add solution first, then water.
Tips
- Descale every 3–6 months, depending on your water hardness. If you notice slower brewing or unusual noises, it’s time to descale.
- Use the official Tassimo descaling solution for best results; it’s specifically formulated for the machine.
- If your machine has a ‘clean’ mode, refer to the manual—some models have a dedicated descaling program.
- Place a paper towel under the spout to catch drips and keep your counter clean.
Troubleshooting
- Machine won’t start descaling: Make sure the water tank is seated properly and the machine is plugged in. Some models require you to press the descaling button twice quickly.
- Water not flowing: Check that the needle in the T DISC holder is not blocked. If it is, clean it with a paperclip (unplug the machine first).
- Descaling indicator stays on: This usually means the rinse cycle wasn’t completed. Run another rinse cycle with fresh water.
- Machine makes loud noises: This is normal during descaling as the pump pushes solution through. If it persists after rinsing, contact Tassimo support.
Frequently Asked Questions
How often should I descale my Tassimo?
Every 3–6 months, or when you notice slower brewing or a change in taste. Hard water areas may need more frequent descaling.
Can I use vinegar or lemon juice instead of the official solution?
No. Vinegar and other acids can damage the internal seals and leave a lingering taste. Use the recommended descaling solution.
How long does the descaling process take?
About 15 minutes in total, including the rinse cycles.
Do I need to remove the T DISC before descaling?
Yes, always remove any pod from the holder before starting the descaling cycle.
What if my machine doesn’t have a descaling button?
Some models use the ‘start’ button; press and hold it for 5 seconds to enter descaling mode. Check your manual for specific instructions.
Can I use a generic descaling solution?
Yes, but make sure it’s citric acid-based and compatible with coffee machines. Avoid solutions with harsh chemicals.
Related
- How to Phone Norway from UK: Step-by-Step
- How to Descale a Smeg Coffee Machine
- How to Phone New Zealand from the UK
Sources: Tassimo. Menus and buttons can differ slightly by version. Spotted something out of date? Tell us.