AjapaReporter

Home life · Updated

How to Wash a WHOOP Band: Step-by-Step Guide

Time it takes5 min
Steps6in the list below
LevelEasyno special skills
Official sourceWHOOP Supportcheck it for changes

Quick answer Wash your WHOOP band with mild soap and warm water, rinse thoroughly, and air dry completely before wearing it again. This keeps the band clean, odor-free, and prevents skin irritation.

What You’ll Need

  • Mild soap (hand soap, dish soap, or baby shampoo)
  • Warm water
  • Clean towel or cloth
  • Soft-bristled toothbrush (optional, for deep cleaning)

Step-by-Step

  1. Remove the band from your wrist. Unclip the WHOOP band from the sensor and set the sensor aside. Do not submerge the sensor itself in water.
  2. Rinse the band under warm water. Hold the band under a gentle stream of warm (not hot) water to remove surface dirt, sweat, and oils. Hot water can damage the fabric or adhesive layers.
  3. Apply mild soap. Put a small drop of mild soap on your fingers or directly on the band. Gently rub the entire band, focusing on the inside where it touches your skin and the areas that collect sweat.
  4. Scrub gently if needed. For stubborn buildup, use a soft-bristled toothbrush with a little soap and water. Scrub in small circles, especially around the sensor holes and seams. Avoid harsh brushes or abrasive cleaners.
  5. Rinse thoroughly. Rinse the band under warm running water until all soap is gone. Soap residue can irritate skin and attract more dirt.
  6. Air dry completely. Pat the band with a clean towel to remove excess water, then lay it flat on a dry towel or hang it. Let it air dry fully before reattaching the sensor or wearing it. Do not use a hair dryer, radiator, or direct sunlight, as heat can warp or shrink the band.

Common Mistakes

  • Washing the sensor. The WHOOP sensor is not waterproof. Only the band should get wet. If the sensor gets splashed, dry it immediately with a soft cloth.
  • Using harsh chemicals. Bleach, alcohol, hydrogen peroxide, or strong detergents can break down the band’s materials and cause discoloration or cracking.
  • Machine washing or drying. The washer and dryer can stretch, tear, or shrink the band. Always hand wash and air dry.
  • Wearing it damp. Putting a wet band back on can cause skin irritation and trap moisture against your skin, which may lead to rashes.
  • Using hot water. Hot water can damage the elastic and adhesive layers, making the band lose its shape or fit.

Tips

  • Wash your band at least once a week, or more often if you sweat heavily or wear it during workouts.
  • Rinse the band with plain water after every sweaty workout to prevent salt and oil buildup.
  • Alternate between two bands if you have them, so one is always dry and ready.
  • Use a dedicated cleaning day, like Sunday, to build a habit.
  • If your band has a strong odor, soak it in warm water with a few drops of mild soap for 10–15 minutes before scrubbing.
  • Keep the sensor contacts clean with a dry cotton swab to ensure accurate readings.

Troubleshooting

  • Band still smells after washing. Soak the band in a mixture of warm water and a small amount of white vinegar (about 1 part vinegar to 3 parts water) for 15 minutes, then wash with soap and rinse thoroughly. Vinegar neutralizes odors without damaging the fabric.
  • Band looks discolored or stained. Try a paste of baking soda and water applied to the stain, let it sit for 10 minutes, then scrub gently with a toothbrush and rinse. Avoid bleach or strong stain removers.
  • Band stretched out or loose. This can happen from excessive pulling or machine washing. If it no longer fits snugly, consider replacing it. To prevent this, always hand wash and avoid tugging when removing.
  • Skin irritation after washing. You may not have rinsed all the soap off. Wash again with plain water and ensure it’s completely dry before wearing. If irritation persists, stop wearing the band and consult a doctor (this is a practical, non-medical note).
  • Sensor not reading properly after cleaning. Make sure the sensor and band contacts are completely dry and clean. Wipe the sensor’s back with a dry microfiber cloth. Reattach firmly and check the app for a connection.

Frequently Asked Questions

Can I put my WHOOP band in the washing machine?

No. Machine washing can stretch, tear, or damage the band’s materials. Always hand wash with mild soap and water.

Is the WHOOP sensor waterproof?

No, the sensor is not waterproof. Only the band is washable. Keep the sensor dry and clean it with a dry cloth if it gets wet.

How often should I wash my WHOOP band?

At least once a week, or more frequently if you sweat a lot or wear it during intense workouts. Rinsing it after each sweaty session helps too.

Can I use hand sanitizer to clean my band?

It’s not recommended. Hand sanitizer contains alcohol, which can dry out and crack the band material. Stick to mild soap and water.

Why does my band smell even after washing?

Odors can be trapped in the fabric. Soak the band in a diluted vinegar solution (1 part vinegar to 3 parts water) for 15 minutes, then wash with soap and rinse thoroughly.

Can I wear my WHOOP band in the shower?

No. The sensor is not waterproof, and wearing it in the shower can damage it. Remove the band and sensor before showering or swimming.

Sources: WHOOP Support. Menus and buttons can differ slightly by version. Spotted something out of date? Tell us.