AjapaReporter

Home life · Updated

How to Stretch Watercolour Paper: Step-by-Step

Time it takes30 min plus drying
Steps7in the list below
LevelMediumsome care needed
Official sourceWinsor & Newtoncheck it for changes

Quick answer Stretching watercolour paper prevents it from buckling when wet. You soak the paper, then tape it to a board and let it dry flat before painting.

What You’ll Need

  • Watercolour paper (140 lb / 300 gsm or lighter; heavy paper may not need stretching)
  • Clean water bath or sink large enough for the paper
  • Sturdy board (wood, Gatorboard, or a purpose-made stretching board)
  • Gummed paper tape (also called kraft tape) – not regular tape
  • Clean sponge or soft cloth
  • Ruler or straight edge (optional)
  • Scissors or craft knife

Step-by-Step

  1. Cut the tape – Cut four strips of gummed tape, each about 2–3 cm longer than the corresponding side of your paper. The tape should be slightly wider than the paper’s thickness.
  2. Soak the paper – Fill a clean bath, tray, or sink with cool or lukewarm water. Submerge the paper completely for 1–2 minutes for 140 lb paper; thicker paper may need 3–5 minutes. Do not leave it too long or it may disintegrate.
  3. Drain and lay flat – Lift the paper by two corners and let excess water drip off. Lay it flat on the board, making sure it is centered and not wrinkled. Smooth out any air bubbles with your hands or a soft cloth.
  4. Activate the tape – Moisten the gummed side of each strip one at a time by running a damp sponge over it. The tape should become tacky but not dripping wet.
  5. Attach the tape – Press one strip along each edge of the paper, overlapping the paper by about 1–2 cm and the rest onto the board. Smooth it down firmly with your fingers or a cloth, ensuring it adheres well.
  6. Let it dry completely – Leave the board flat in a dry, warm place. Drying can take several hours or overnight. Do not use a hairdryer or radiator, as rapid drying may cause cracking.
  7. Check and paint – Once the paper is dry, it should be taut and flat. You can now paint on it. When the painting is finished and dry, cut the tape with a craft knife and remove the paper.

Common Mistakes

  • Over-soaking – Leaving paper in water too long makes it mushy and weak. Stick to recommended times.
  • Using wrong tape – Regular masking tape or sellotape will not stick when wet and will peel off. Gummed tape is essential.
  • Not drying flat – If you dry the board upright or in direct sunlight, the paper may dry unevenly and still buckle.
  • Rushing the drying – Painting on damp paper will cause immediate buckling. Wait until it is completely dry.
  • Air bubbles under paper – Not smoothing out bubbles before taping leads to bumps after drying.

Tips

  • For very heavy paper (300 lb / 640 gsm), stretching is often unnecessary; it may not buckle.
  • Use cool water – hot water can damage the paper’s sizing.
  • If you are in a humid climate, drying may take longer; allow extra time.
  • You can reuse the board after removing the tape; scrape off any residue.
  • For a quick alternative, use a wet-strength tape like a linen tape, but gummed kraft tape is the most reliable.

Troubleshooting

  • Paper still buckles after drying – The tape may not have adhered well. Check that the tape was fully moistened and pressed firmly. Re-stretch with fresh tape.
  • Tape peels off during drying – The board might be too smooth or the tape not wet enough. Sand the board lightly or use a rougher board. Also ensure the tape overlaps the paper by at least 1 cm.
  • Paper tears when removing tape – Moisten the tape with a damp sponge before pulling. Gently lift from one corner, pulling away from the paper.
  • Paper has a wavy edge – This happens if the paper was not soaked evenly. Submerge it fully and ensure it is flat before taping.
  • Mold or mildew on paper – If drying takes too long in a damp area, mold can grow. Dry in a well-ventilated space and avoid leaving it wet for over a day.

Frequently Asked Questions

Do I need to stretch all watercolour paper?

Only paper lighter than 300 lb (640 gsm) tends to buckle. Heavy paper stays flat without stretching. If you are unsure, test a small piece.

How long should I soak the paper?

For 140 lb (300 gsm) paper, 1–2 minutes is enough. Thicker paper may need up to 5 minutes. Soaking too long weakens the paper.

Can I use a hairdryer to speed up drying?

No. Rapid drying causes the paper to shrink unevenly and crack. Let it dry naturally at room temperature.

What board should I use?

Any rigid, waterproof board works: wood, Gatorboard, or a purpose-made stretching board. Avoid boards with a glossy surface that tape won’t stick to.

Can I reuse the paper after stretching?

Once stretched and painted, the paper is usually not reusable. But you can cut off the taped edges and use the center for small pieces.

What if I don’t have gummed tape?

You can use a staple gun to staple the wet paper to a wooden board, but this leaves holes. Gummed tape is the best method; it is inexpensive and available at art stores.

Sources: Winsor & Newton. Menus and buttons can differ slightly by version. Spotted something out of date? Tell us.